Remove residue and clean your build plate with ease
PrintaClean is a powerful solvent to remove dust, dirt and adhesive residue from the 3D printer build plate.
- Remove the build plate from the 3D printer. The build plate should be at room temperature and without damages.
- Spray a generous amount of PrintaClean on the build plate. Allow the solution around 30 seconds to disolve any residue
- Wipe off the solution with a kitchen towel.
Hazardous and Precautionary Statements:
- P101-If medical advice is needed, have product container or label at hand.
- P102-Keep out of reach of children.
- P210-Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
- P337+P313-If eye irritation persists: Get medical advice/attention.
- P501-Dispose of contents/container safely.
- H225-Highly flammable liquid and vapour.
- H319-Causes serious eye irritation.